When you enable ICS, your local area network (LAN) connection gets a new static IP address and configuration, so you’ll need to reestablish any TCP/IP connections between your host computer and the other network computers. Optionally, to allow other network users to use services running on your network, click Settings and select the services you want to allow. If desired, you can also select the Allow other network users to control or disable the shared Internet connection check box.ĥ.
LOOPBACK ADAPTER INSTALL
For the same, you’ll have to install Microsoft Loopback Adapter if you have only one network card installed on the PC.Ĥ. Also, you can read more about loopback capturing on the Wireshark Loopback capture setup wiki page. Commonly used for network administration and installation tasks, these RJ45 loopback adapter cables are a useful way to make a network device communicate with itself without carrying around a network hub. The Sharing tab will not be available if you have only one network connection. I doubt very much that the Microsoft Loopback Adapter is what you need. Click the Sharing tab, and then select the Allow other network users to connect through this computer’s Internet connection check box. If you are prompted for an administrator password or confirmation, type the password or provide confirmation.ģ. Right-click the connection that you want to share, and then click Properties. Open Network Connections by clicking the Start button, clicking Control Panel, clicking Network and Internet, clicking Network and Sharing Center, and then clicking Manage network connections.Ģ.
LOOPBACK ADAPTER HOW TO
Note that to enable Internet Connection Sharing in Windows XP, you must have administrative rights.įor more information, click How to configure Internet Connection Sharing in Windows XP which provides Video demo of the above activity.ġ. If these other computers have static IP addresses, it is a good idea to set them to obtain their IP addresses automatically. Your computer may lose connectivity with other computers on
![loopback adapter loopback adapter](http://www.ossmann.com/images/loopback.jpeg)
When Internet Connection Sharing is enabled, your LAN adapter will be set to use IP address 192.168.0.1. If you want to permit other network users to enable or to disable the shared Internet connection, click to select the Allow other network users to control or disable the shared Internet connection check box.ĥ. On the Advanced tab, click to select the Allow other network users to connect through this computer’s Internet connection check box.Ĥ. Click the local area network (LAN) connection, the one that connects to the Internet), and then under Network Tasks, click Change settings of this connection.ģ. Click Start, click Control Panel, and then double-click Network Connections.Ģ.
![loopback adapter loopback adapter](https://cables4sure.com/25624-thickbox_default/singlemode-sc-loopback-cable.jpg)
To enable Internet Connection Sharing in Windows XP, follow these steps:ġ. That is configured to connect to the Internet. To use Internet Connection Sharing to share your Internet connection, the host computer must have one network adapter Step # 2 – Configure Internet Connection Sharing